So you have asked for help with your face design and you want to share your draft face in Inspection Mode so that others can see your expressions - this is how you do it:
…
Steps to share an Inspection Mode link:
A. In the watch browser, click on the “Enable Inspection” item in the pull down menu next to the face
( enlarged below )
B. In the same pull down menu, click on the “Share” item to open a new window displaying the watch with the inspection icon ( a small rocket ) visible. If left-clicking on the “Share” item does not work then try right-clicking and select “open in new window”.
The preview should show the icon as follows:
( enlarged below )
C. Copy the full web address from the address bar in the browser and past it into your post. The address should look something like this:
" https://www.facer.io/watchface/iGcdTv5bjR/showcase?prev=~2Fwatchface~2FiGcdTv5bjR~2Fedit&draft=true "
D. When you insert the link into a post it won’t show the actual preview, it will look like this:
…
That is it, others can now follow this link, press on the rocket symbol and see your expressions. When you are finished getting help you can disable inspection mode if you want to by going back to the pull-down menu in the brower and disable inspection mode for the face.
I hope that was helpful.
