Moon phases with a pointer

Support
1

Hi, everyone,
I saw on a watchface from @RZwatchfaces (see here) that you can display the moon phases with a pointer.
I would recreate this in a similar way.
Namely in the lower half of the clock and then horizontally!
The original formula is (interpDial(#MOONPHASE#, 0, 7, 180, 0))

Unfortunately, I cannot assign the digits from the formula.
The “180” is probably the end position of the pointer and the “7” is probably the jump distance!?!?!
But which “0” is the starting position? I’ve tried a few things, but not everything works 100%.
Please help me and thank you in advance.

Screenshot 2022-11-27 195242
Screenshot 2022-11-27 195242954×405 63.4 KB

Unbenannt - 9
Unbenannt - 91829×876 86 KB

2 Likes
2

I will have a look stand by .

A problem we have is the Image is not symmetric .
when it is layer out in a line like that it is best to have the New Moon both ends so The full is in the middle but For a small watch Face this is Pretty good .

Here is the resource I generated . was a bit rushed but it Illustrates the point .

pointer moon 640
pointer moon 640640×640 43.2 KB

2 Likes
3

Thank you @russellcresser , you have once again been a great help to me.

1 Like
4

Gosh. Moon distance is intresting. Split those you hrs mins and seconds up. Stop them dancing.